1) Remove Glass & Back door
2) Disconnect both screw drive motors from back LED board

3) Power on game, servo should cycle from Ball gate to return hole and back to Ball gate
4) Connect to game with the Ice Cold Beer app

5) Select Calibration then select Servo

6) Press the Test button after the Return Hole adjuster & Servo will cycle to the Ball Return hole. Place Game Ball in Bottom hole & press Ball Gate test button. Servo Disc should cycle Game Ball to Ball Gate Hole and Ball should rest against ball Gate.

7) If Ball Does not Slide into Servo Disc, use Slide adjuster to position disc so the Ball slides into Disc slot completely. Press Ball Gate test button & ball should return to Ball Gate. If Ball Does not, use Ball Gate adjuster to reposition Servo Disc so Ball falls to gate smoothly.

8) After performing adjustments press Apply changes to save settings, power off game & reconnect screw drive motors.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment