The hole test is to test the lit holes to make sure they light in the right sequence. The bar test is to insure the bar will travel the entire playfield without binding. The Errant Ball test is to test the errant ball switch and servo to make sure they function properly. Follow the instructions below before performing each of these test.

1. Open the Coin Door and unlatch the Control Panel, tilt the Control Panel forward and remove the playfield glass. Place the ball shipped separately in through any hole on the playfield.

2. Turn the game on.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment