1) Power Game off then back on again. Servo motor should cycle to Return Hole than back to gate hole.
2) unplug servo unit and remove from playfield
3) Remove Allen screw (2.5 mm) holding disc to motor
4) Remove disc from assembly and rotate so slot in disc lines up with alignment hole as shown
5) Press disc back onto servo motor
6) Apply Blue loctite to allen screw and tighten, Do not over tighten screw Reinstall Servo assembly and follow Servo Alignment Procedure


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment